Utah Wildlife Forum banner
1 - 12 of 12 Posts

· Registered
Joined
·
4,477 Posts
Discussion Starter · #1 ·
I am looking for a used hyper, or longtail mud motor for a 16 ft. Landaue boat. I have the shorter transom, so if I get a hyper, it will have to work for a "short shaft" boat.

Anyone can help let me know.
 

· Registered
Joined
·
4,477 Posts
Discussion Starter · #10 ·
Thanks for the help guys!! I went out to my "old haunt" this morning, and had to push the boat off the trailer to get it in the water :x I had the outbourd motor on it, and made it about 200 yards before I slamed into the mud and got stuck. :evil: I spent the rest of the morning getting the boat back to the floating stage, and went back to the truck. I was a mad dude to say the least. I had had enough of this Horse Crap!! I stopped into Mudbuddy and got a new Hyper drive :lol: :lol: I pick it up tomorow.

Thanks for the help, and best of luck to you in the hunting future!
 

· Registered
Joined
·
301 Posts
Duurty1 said:
i have a 16 by 38 and i got the 23 horse. andy, the distributer, has a 14 by 38 and he also has the 23, he says that the only thing that has beat him yet was a 35 horse hyper-drive
i dont know if i buy that. i have a scavenger with a 20 hp motor pushing a 1648 and i get my clock cleaned all the time by other mudd motors on speed and how shallow they will run. i have a buddy who has a 20' boat with a shorty...there is no comparison as to where he can go and i cant. top speed on my 1648 with no gear is only 12 mph on the gps. the 1440 jon i did have earlier in the spring went a bit faster but not much. dont get me wrong here, i love my set up but i what i saw last week with a guy in an 18' boat and a shorty...well he was going in ankle deep water. i pushed my boat to where he just flew right on by......
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top